您现在的位置:首页>>中心>>EMC测试及认证>>FCC认证>>正文
在线咨询

FCC Part 68新要求

FCC Part 68新要求

  • 本站
  • 2010-01-12
  • 法规
  • 已浏览

FCC Part 68所引用的测试要求TIA-968-B已于2009年9月公布,与TIA-968-A和其附属条款A-1、A-2、A-3、A-4 and A-5的差异有10项,请见原文详细说明如下:

1. The structure of the document was entirely changed to reflect a redirected emphasis on interface types instead of test types;

2. Tolerances were added for Type A and Type B surge wave shapes;

3. The clause on leakage current limitations was rewritten for clarity but the requirements remain the same;

4. Coin deposit signals were added along with DTMF as examples of signals generated by terminal equipment that are used for network control;

5. Requirements that were inadvertently deleted in TIA-968-A have been restored for data circuit terminal equipment intended to operate with a programming resistor for signal level control;

6. Clarified that the tip ground state of loop start central office implemented telephones does not require transverse balance testing;

7. Clarified in the applications section that terminal equipment must comply with the applicable technical criteria of this Standard at any control adjustment employed;

8. Annex A was clarified by limiting the grandfather clauses for non-approved equipment to the United States;

9. New requirements were added for ADSL all digital mode, reach-extended ADSL and VDSL2. Other DSL requirements previously referenced from T1.417 were also added;

10. Component approval requirements previously located in TSB-129-A were included in this Standard;

其中最引人注目的是:VDSL增加了30a的Profiles。


返回顶部
认证信息检索:
站内搜索.. 模糊搜索:

广朋咨询服务有限公司© 版权所有

客服热线: 020-8148 6695, 8165 9395 传真: 020-8165 9395; Skype: liyun_01 E-mail: mike@gptek.com.cn

在线咨询互动服务: 客服1 互动服务: 客服2 粤ICP备14072239号